Xerox DocuColor 3535 Color Manual page 58

2
2-22 Color Calibration
When the patch has been measured successfully, a check mark appears in the patch
preview in the Measurements window. The window identifies and highlights the next
patch to be measured.
10. Repeat step 9
Start with A1 and continue down Column A. When you have finished measuring all
the patches in Column A, proceed to Column B in the same manner until all columns
have been measured.
To retake a measurement, select the desired patch preview in the Measurements
window and measure the patch on the page using the ES-1000 or ED-100.
You must take the measurements in the order outlined in the Measurements
N :
OTE
window and on the measurement page.
11. When all the patches have been read successfully, click Accept.
12. Click Apply in the Calibrator window to implement the new calibration set.
13. Click OK in the Information dialog box.
This completes the Fiery calibration process.
to measure each successive patch on the Measurement Page.