Finisher - Xerox CopyCentre C35 Quick Reference Manual

Check that the Touch Screen is displaying the correct size for the paper in use.
Load fresh paper.
Repeated Check Tray Messages on the Touch Screen
and the paper is loaded in the tray
Adjust the edge guides against the stack of paper in the tray.
If the edge guides were not set against the paper stock in the tray when Start
was selected, delete the job in the job queue and begin again.
Paper Curls
Load the paper in the paper trays with the seam side of the paper up. Load the
paper in the Bypass Tray with the seam side down.
Load non-standard media in the Bypass Tray.
If the paper curls excessively, flip the paper over in the applicable paper tray.

Finisher

The Finisher does not stack the output correctly
Unload the finisher tray frequently.
Do not remove stapled sets while the finisher is compiling.
The Finisher does not staple or staple well
Use less than 50 sheets of paper if they are heavier than 20lb.
The maximum number of sheets is 20 when stapling heavyweight paper.
Check the Touch Screen for a fault message indicating no staples. Replace the
staple cartridge.
Quick Reference Guide
The seam refers to the side of a ream of
paper with a split in the wrapping. It may
also be referred to as arrow side first.
Page 11-7