Table of Contents
Advertisement
SECTION 7: FUEL & PROPANE SYSTEM
EXHAUST GAS FUMES
(See page 59)
To prevent inhaling exhaust gases, follow these guidelines:
•
Always shut OFF the tow vehicle engine, generator engine (if
applicable), etc., while refueling.
•
Do not run the tow vehicle engine, generator engine (if
applicable), etc., in confined areas, such as a closed garage, any
longer than needed to move your RV in or out of the area.
•
Windows should be closed while driving or running the generator
(if equipped) to avoid drawing dangerous exhaust gases into the
RV.
•
If you suspect that exhaust fumes are entering the RV, have the
cause determined and corrected as soon as possible.
The best protection against carbon monoxide entry into the RV
is a properly maintained ventilation system and an active carbon
monoxide detector. To allow for proper operation of the RV ventilation
system, keep the ventilation inlet grill(s) clear of snow, leaves or other
obstructions at all times.
See "SECTION 2: OCCUPANT SAFETY" on page 8 for additional
information on carbon monoxide safety.
PROPANE GAS SYSTEM
(See page 59)
Propane or LP (liquefied petroleum) gas is an efficient
form of energy when proper handling and safety
precautions are observed. The propane system in
your RV furnishes the fuel for cooking, heating, hot
water and can be an alternative energy source for
refrigeration.
Propane is heavier than air; and tends to flow to lower areas and
will sometimes pocket in these low areas, such as the floor. Your
RV is equipped with a propane alarm (refer to "COMBINATION
CARBON MONOXIDE /PROPANE ALARM" on page
9).
FUEL & PROPANE SYSTEM
The propane fuel system is comprised of numerous components such
as the propane container, hoses, the propane gas regulator, piping,
and copper tubing to each appliance.
Although your RV has been carefully tested at the factory, and by
your selling dealer for leakage, travel vibrations can loosen fittings.
Have the propane system checked at all connections soon after the
purchase of your RV, and after the initial filling of the propane tanks.
Continued periodic checks of the propane system at 5,000 miles of
travel (or at least once a year), by a qualified propane service
representative as part of your normal maintenance is recommended.
Hand tighten the LP gas system valves only, do not use a wrench or
pliers as over tightening may damage the valve seals and cause them
to leak.
All propane lines have been checked with air pressure at the time of
manufacture. Dealers are required to recheck and adjust pressure
before retail delivery.
Propane Gas Container
DOT (Department of Transportation) cylinders are transportable and
are commonly used on RVs. DOT propane cylinders are required to
be removed from the RV for filling and must be filled by weight by a
qualified propane facility. DOT Propane cylinders are equipped with
an OPD (over fill protection device) designed to reduce the potential
of overfilling.
DOT cylinders are typically marked with "top" or an arrow to indicate
U
Y
NIVERSIT
the correct orientation of the cylinder(s). Do not mount, store or
transport any cylinder other than in the proper position indicated.
Be sure to securely re-install DOT cylinder(s) to the RV after they
have been removed for filling or replacement. Always close the
service valve and install a dust cap or plug when transporting or
storing disconnected containers whether full or empty.
(See page 59)
7
Page 55
Advertisement
Table of Contents
