Solar Prep (If Equipped) - Jayco TOWABLE 2024 Owner's Manual

SOLAR PREP (IF EQUIPPED)

(See page 54)
Your recreation vehicle may be wired with a connection for the solar panel(s) and solar controller(s) to charge the battery. These come in 3
configurations:
1. An exterior port on the side wall, A-frame, or in the utility center that allows a suitcase style controller/solar
panel combo to be plugged in. This port is wired to the battery via a 20-amp 12-volt circuit breaker.
2. A roof mounted port for a solar panel connection, and wiring to a location in an interior or basement wall
where a solar controller may be installed. The capped off wiring in the wall for the controller then continues on
to chassis ground and to the battery through a 30-amp 12-volt circuit breaker. A decal on the wall shows the
wiring location, and a diagram of where to mount the controller.
3. A roof mounted port for a solar panel connection, and wiring to a location in the front basement compartment where a solar controller may
be installed. The capped off wiring in the basement compartment then continues on to chassis ground and to the battery through a 30-amp
12-volt circuit breaker, and to a JAYCOMMAND/TravelLINKcontrol panel used to manage the system. A decal on the basement wall panel
shows the wiring location for the controller.
Contact your dealer for help with your solar installation. You can also find more info at WiredForSolar.com.
Exterior Sidewall
or Utility Center
Suitcase Style Combo
Controller/Solar Panel
Wiring Port
ELECTRICAL
Interior Decal
Showing Solar
Controller Wiring/
Mounting Location
1
JAYCOMMAND/
TravelLINK Connector
Roof Mounted
Solar Panel
Wiring Port
2
JAYCOMMAND/
TravelLINK
Interior Decal
Showing Solar
Controller Wiring
Location
6
3
Page 51