Table of Contents
Advertisement
LEVELING SYSTEM (IF EQUIPPED)
(See page 32)
The Leveling System is an electric 4 or 6-point automatic leveling
control. The system utilizes one main control board and a separate
waterproof remote level sensor to measure and manage level point. It
can be operated by the Auto Leveling Control Touch Pad - Mounted
outside the RV within view of the hitch.
Refer to the manufacturer's user manual included in your Customer
Information Packet for complete safety and operating instructions.
Auto Leveling Control Touch Pad
A - Red/Green LED indicates
system status
B - Up Arrow extends front jacks
(landing gear)
C - Down Arrow retracts front
jacks (landing gear)
D - Auto Level button places
system in the auto level mode
E - Hitch Height button initiates the Hitch Recognition feature
F - Retract All button puts leveling system in full retract mode
Pressing both the arrow buttons simultaneously turns on the
touchpad. Touchpad will time out after 7 minutes of non-use.
Auto Level Touchpad LED Indicator status
•
OFF - Touch pad is locked
•
Solid Green - Touch pad is active
•
Blinking Green - Jacks are moving
•
Solid Red - Low battery
•
Blinking Red - Error
The OneControl touch screen or Leveling App will show the specific
error.
Refer to troubleshooting section of the manufacturer's manual to clear
the error.
Unhitching the RV
1.
Before unhitching from the tow vehicle, ensure the RV is parked
on a level surface and tires are chocked.
2.
Extend the inner legs of both landing gear (front jacks) to within
4"- 5" of the ground by pulling on the quick release pins.
3.
Turn on the touchpad by pressing both arrow buttons
simultaneously. LED illuminates solid green.
4.
Press the UP arrow button to extend the front jacks to lift the
front of the RV taking weight off the hitch.
5.
Uncouple the RV connection to the tow vehicle. Pull tow vehicle
away.
Page 20
VEHICLE OPERATION
A
B
C
D
Auto Leveling
When the leveling cycle has started, it is important there is no
movement inside the RV until leveling is complete. Failure to
remain still during leveling could affect the performance of the
leveling system.
1.
Turn on the touchpad.
2.
LED will light up solid green.
3.
Select AUTO LEVEL and the auto leveling process begins.
Front of the RV will seek a position near level. Rear jacks will be
grounded (on 4-point system). Side to side leveling will begin.
4.
Each jack will perform a final grounding touch.
On a 6-point system, the (2) middle jacks will be grounded to stabilize
the trailer. The (2) middle jacks do not level the RV.
E
If the AUTO LEVEL sequence does not perform as described
F
above, place the system in manual mode and test that the jacks
operate correctly by using the OneControl touch panel inside the
RV.
STABILIZERS
Each stabilizer can be individually adjusted to stabilize the RV for use.
Make sure the RV is level BEFORE using the stabilizers.
When setting up on soft ground, you may wish to place a wood pad
or the equivalent under each stabilizer foot to help keep the stabilizer
from sinking into the ground.
Manual Stabilizers (if equipped)
1.
To lower each stabilizer, insert the crank onto the applicable
stabilizer shaft.
2.
Turn the crank clockwise to lower each leg until it contacts the
ground and stabilizes the RV.
To raise each stabilizer, insert the crank onto the applicable stabilizer
shaft and turn the crank counter-clockwise.
Jayco Rock Solid Stabilizer System (if equipped)
Hex Coupler
Safety Chain
Inner Arm
Spring Latch
Key Ring
Quick Drop Leg
Rock Solid Stabilizer Components
(See page 32)
Assembly Body
Visual Gauge
Footpad
Outer Arm
Advertisement
Table of Contents
