Table of Contents
Advertisement
E-Z LUBE
OR SUPER LUBE
®
The E-Z Lube or Super-Lube
feature on your axles
provides the ability for the
bearings to be periodically
lubricated without removing
the hubs from the axle. When
grease is pumped into the
grease fitting, it is channeled
to the inner bearing and
then flows back to the outer
bearing and eventually back
out the grease cap hole. Be sure to spin the wheel as you fill to allow
for even distribution of grease to the bearing.
Contact your dealer for additional assistance.
The convenient lubrication provisions of the E-Z Lube or Super Lube
feature must not replace periodic inspection and maintenance of
the bearings. Use a hand-operated grease gun; improper use of a
commercial grease gun may damage the seals.
EXTERIOR ROOF AND SIDEWALL VENTS
Inspect the roof vents, including sealants for cracks and keep them
clean. Inspect the refrigerator and holding tank vents for blockages
from bird nests, spider webs, leaves, etc. All exterior access doors
and vents need to be kept clean and free of obstructions (i.e., insect
nests, mud daubers, etc.) while the appliances are in use.
WINDOWS
Any ventilating window may permit water inside, especially during
heavy rainstorms. Condensation will also cause water to accumulate
on windows and in the tracks.
Window glass
The window glass can normally be cleaned with a sponge and water.
Use glass cleaner to remove wax, oil, grease, dead insects, etc. After
washing the glass, wipe it dry with a clean, soft cloth.
EXTERIOR LADDER (IF EQUIPPED)
(See page 102)
Your RV may be equipped with an exterior roof ladder. The RV roof
has decking under the rubber roof membrane to allow you to walk on
the roof (with caution) to do maintenance.
Page 100
EXTERIOR
AXLE (IF EQUIPPED)
TM
Remove Grease
Cap Plug to
Access Fitting
Grease
Fitting
Grease
Cap Plug
E-Z Lube/Super Lube Axle Example
Self-Storing Ladder (If Equipped)
Some models may be equipped with a self-storing ladder mounted to
the side of the RV. Max capacity for this type of ladder is 250 lb.
Ladder should be in the storage position while traveling.
Self-storing ladder operation
1.
Pull all the locking pins out of
the ladder brackets (A).
2.
Pull the ladder down and
toward you and it will swing
away from the RV.
3.
When the brackets are
extended (B), re-insert the
pins to lock the ladder in
place while in use.
4.
To return the ladder to the
storage position; pull the
locking pins and push the
ladder up and in towards the
RV.
5.
When the ladder is in the
storage position, re-insert all
locking pins to prevent the
ladder from opening while traveling.
A
B
Advertisement
Table of Contents
