Table of Contents
Advertisement
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide
Procedure
Step 1 Switch on the lithium battery circuit breaker.
Step 2 Press the Manual ON/OFF button on the lithium battery to activate the lithium
battery.
Step 3 Press the switch for 2–5 seconds. The system is powered on when you hear a
sound from the contactor.
Step 4 Check whether the lithium batteries communicate properly. If the run indicator on
a lithium battery is steady on, the battery communicates properly with the
monitoring device. If it blinks fast (4 Hz), the communication between them is
interrupted. If so, check whether the communications cable is properly connected.
Step 5 Observe the lithium batteries for 15 minutes. The lithium batteries are running
properly if the alarm indicators are off.
Step 6 Set all circuit breakers to the appropriate status based on site requirements.
Step 7 Observe the power system for 15 minutes. If no alarm (except the door status
alarm) is generated on the SMU during this period, the current and voltage for
batteries and loads are normal.
----End
8.2 Setting the Display Language
After powering on the SMU, press
language. Then press
8.3 Setup Wizard
After Setup Wizard Init is displayed on the LCD, set the following parameters.
Table 8-1 Parameter settings
Item
Setting the
time zone.
Set the date
and time
Battery Vendor
Issue 01 (2021-05-30)
NO TE
● If an undesired language is selected, reinstall and restart the SMU and then select the
desired language.
● The preset password for login is 000001.
Setting Value
Set this parameter to the local time zone.
Set this parameter to the local date and time.
Set the parameters based on site conditions.
Copyright © Huawei Technologies Co., Ltd.
or
on the LCD to select a display
to enter the standby screen.
8 Commissioning
53
Advertisement
Table of Contents
