Table of Contents
Advertisement
MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide
5.3 Installing DC Output Power Cables
Connecting DC Output Power Cables to 125 A Circuit Breakers
Step 1 Use cables (cross-sectional area: 10–35 mm
DC output power cables.
Table 5-1 Preparing cables
Cross-Sectional
Area
2
10 mm
2
16 mm
2
25 mm
2
35 mm
Figure 5-7 Preparing a cord end terminal
(1) Cable
Step 2 Install DC output power cables.
1.
2.
3.
Issue 01 (2021-05-30)
Recommended Cord End Terminal
Specifications
Pre-insulated and with an insertion
depth of 18 mm
Pre-insulated and with an insertion
depth of 18 mm
Pre-insulated and with an insertion
depth of 18 mm
Not pre-insulated; with an insertion
depth of 18 mm
Loosen the screws for the DC output circuit breakers.
Connect DC output power cables to the corresponding DC output circuit
breakers.
Tighten the screws for the DC output circuit breakers.
NO TICE
Tighten the screws until they are flush with the thread, indicating that the
screws are fastened properly.
Copyright © Huawei Technologies Co., Ltd.
2
) and cord end terminals to prepare
Recommended Bare Wire
Specifications
25–35 mm
NOTICE
Cord end terminals are recommended.
When bare wires are used, you are
advised to add heat shrink tubing to
ensure that the wire ends are not split.
(2) Cord end terminal
5 Installing Cables
2
(3) Crimping tool
34
Advertisement
Table of Contents
