Alarms - Janome Quilt Maker Pro 16 User Manual

User Manual
To perform the X-Mo琀椀 on Sensor Test
Use the X-Mo琀椀 on Sensor test to verify func琀椀 onality of the X-axis s琀椀 tch regulator encoder (the encoder
mounted at the rear of the carriage).
• Press the X-Mo琀椀 on Sensor test bu琀琀 on. Slowly move the machine le昀琀 and right. You should hear a
pulsing beep that pulses faster as you move the carriage faster. A solid beep, no beep, or periods of
irregular beeping (with constant mo琀椀 on) indicate a problem with the X-axis encoder.
 NOTE: The most likely cause of a problem is a s琀椀 tch regulator wheel that is not making consistent
contact with the track. Check the spring tension on the sensor assembly on the carriage to ensure
that it will easily return to the fully extended posi琀椀 on a昀琀 er being compressed. Also ensure that
the track is straight with no dips or indenta琀椀 ons and that it is clean and free of lint build-up. Other
causes are an unplugged or damaged cable or possibly an issue with the main control board.

Alarms

The Alarms screen has two alarms: the overspeed alarm and the quil琀椀 ng alarm.
44
QUILT MAKER PRO 16
• Touch the Tools icon in the toolbar. Then touch the Alarms bu琀琀 on to open
the Alarms screen.
The overspeed alarm
alerts you if you are
moving the machine
faster than 100% of
the motor capacity.
The quil琀椀 ng alarm
enables you to set
琀椀 med reminders.
www.janome.com