Alarms - Janome Quilt Maker Pro 16 User Manual

User Manual
To perform the X-Moti on Sensor Test
Use the X-Moti on Sensor test to verify functi onality of the X-axis sti tch regulator encoder (the encoder
mounted at the rear of the carriage).
• Press the X-Moti on Sensor test butt on. Slowly move the machine left and right. You should hear a
pulsing beep that pulses faster as you move the carriage faster. A solid beep, no beep, or periods of
irregular beeping (with constant moti on) indicate a problem with the X-axis encoder.
 NOTE: The most likely cause of a problem is a sti tch regulator wheel that is not making consistent
contact with the track. Check the spring tension on the sensor assembly on the carriage to ensure
that it will easily return to the fully extended positi on aft er being compressed. Also ensure that
the track is straight with no dips or indentati ons and that it is clean and free of lint build-up. Other
causes are an unplugged or damaged cable or possibly an issue with the main control board.

Alarms

The Alarms screen has two alarms: the overspeed alarm and the quilti ng alarm.
44
QUILT MAKER PRO 16
• Touch the Tools icon in the toolbar. Then touch the Alarms butt on to open
the Alarms screen.
The overspeed alarm
alerts you if you are
moving the machine
faster than 100% of
the motor capacity.
The quilti ng alarm
enables you to set
ti med reminders.
www.janome.com