Installa琀椀 On And Setup; Carriage - Janome Quilt Maker Pro 16 User Manual

User Manual
Installation and Setup

Carriage

You should have already set up the Janome Quilt Maker Pro 5' Quil琀椀 ng Frame™. Refer to the frame manual
for detailed instruc琀椀 ons about se琀� ng up the frame.
To install the carriage and machine on the frame
1. Place the carriage on the table rails, ensuring
that the carriage s琀椀 tch regula琀椀 on encoder faces
the back of the frame.
2. Place the machine on the carriage.
 CAUTION: The Quilt Maker Pro 16 is heavy.
Never a琀琀 empt to li昀琀 it alone. Always use
two people when li昀琀 ing. Always li昀琀 from
the throat of the machine, not from the
handlebars or needle bar.
3. Plug the end of the single ribbon cable from
the machine s琀椀 tch regulator encoder connector
at the back of the machine into the s琀椀 tch
regula琀椀 on encoder on the carriage.
 NOTE: The 9 pin cable plugs into a a serial connector socket on the back of the machine (see item
30 on the previous page). The ribbon cable then runs to the machine encoder on the right rear
wheel of the machine. The Y connec琀椀 on plugs into the machine encoder. Lastly the single end of
the ribbon cable runs to the carriage encoder.
 IMPORTANT: If you ever need to remove the machine from the carriage, disconnect the ribbon
cable from the s琀椀 tch regulator at the back of the carriage. Failure to unplug the cable when
removing the machine from the carriage could result in damage to the cable, encoders, and
carriage.
 IMPORTANT: The connector is keyed to ensure correct alignment. Make sure the keyed por琀椀 on of
the cable connector aligns with the keyed por琀椀 on of the encoder connector. Do not force.
www.janome.com
QUILT MAKER PRO 16
13