Table of Contents
Advertisement
FQSteX
PD-4 DIGITAL AUDIO RECORDER
The following conditions apply to S-ID/P-NO recording:
1)
The P-NO to be recorded is the number currently displayed plus one.
2)
Immediately after detecting BOT, P-NO "001" will be recorded.
3)
Whenis displayed, only S-ID will be recorded, not P-NO.
4)
When the P-NO is edited, the edited P-NO will be recorded.
(110) Error tone
I I
I I u
In
n
u
Turn the error tone on or off.
00
Off.
01*
On.
The error tone is a 1 kHz pulsating tone that is output to the built-in loudspeaker or stereo
headphones to warn of a malfunction. The error tone sounds for the following conditions:
1)
When the average BER (block or burst error rate) of 8 frames is greater than 10%. The
PCM ERR LED (23) is illuminated red.
2)
When clipping occurs in the input channel amplifier. The PEAK LED is illuminated.
3)
When the power supply voltage is abnormal - either below IIV or above 16V.
Note:
The error tone will not be heard if the MONITOR control is turned OFF.
(Ill) LCD contrast
/
/
/
/
II
r
IL
L
Set the contrast for the LCD screen.
00
Minimum contrast level
ni
u t
07*
Maximum contrast level
Silence detection functions
(SU 201): Silence detection level setting
IR
I
IL
uc
If SETUP mode fimction 106 is set to Auto (02), this function determines the signal level
threshold before a S-ID/P-NO is recorded.
00
01
02
*
-20 dB
-30 dB
-40 dB
48
SETUP mode functions
Advertisement
Table of Contents
