Table of Contents
Advertisement
Fostex
PD-4 DIGITAL AUDIO RECORDER
Power and other controls
Figure 6
Power and other controls
36)
POWER switch
This is the main power switch. Power is immediately shut off by flipping this switch to
OFF. The switch is recessed to prevent it from being switched accidentally.
37)
GEN switch
This switch will continue to supply power to the ECU and CPU even when the main
power is switched OFF. The internal time code will run at crystal precision. The battery
(NP-IB) will last for approximately 8 hours in this mode.
Precaution:
After you have used the internal battery (NP~1B) for more than eight hours in
TC GEN CONT mode, the PD-4 may not power on when you turn the POWER switch (36) OFF
and then ON again. In this case, the battery may have been used up. After replacing the battery,
turn OFF the GEN switch, turn OFF the POWER switch, then wait a few seconds and turn the
power ON again.
38) MONITOR control
This rotary control adjusts the level of the monitor signal. This control is a push-lock
type. Once you have set a desired level, push the control in to prevent accidental
adjustment.
The signal is heard through the built-in loudspeaker (42) or a set of stereo headphones
connected to the PHONES jack (39). To turn off the monitor, rotate the control counter¬
clockwise until it clicks OFF.
Controls 8c Connections
15
Advertisement
Table of Contents
