Fostex PD-4 Owner's Manual page 30

Portable digital audio recorder

Hide thumbs Also See for PD-4:

Table of Contents

Additions to the PD-4 Owner's Manual

In relation to version up (V1.03) of the PD-4 software, the following items were added in the SETUP mode

of this equipment. Aa the newly added functions are explained only here, please read this together with

the main text.

SETUP mode additional functions

1. Setup of the pause mode disengage time [SU104] (New addition)

Previously, the pause mode disengage time was fixed at 3 minutes but with

addition of "SU 104" in the SETUP mode, the disengage time can be set to

several different lengths.

Time setting can be selected from 30 seconds, 1,2, 3, 4 and 5 minutes by

their assigned numbers as listed below (Initial setting is "03.")

10 HP cl

I Disengaged after 30 seconds.

i Disengaged after 1 minute.

i Disengaged after 2 minutes.

1.03.(1 ; Disengaged after 3 minutes.

! Disengaged after 4 minutes.

1 Disengaged after 5 minutes.

Two items on output conditions and the setup mode "02" [SU 110] are

added to the ON/OFF setting of error tone output.

When the mode is set to "01" (ON) the error tone output conditions are

THE TAPE REMAINDER WHEN RECORDING BECOMES LESS THAN 5

MINUTES and WHEN EXT TC iS INTERRPTED. These have been added

and an error tone will now be output for about 3 seconds when either one of

the output conditions have been met.

Furthermore, "02" has been added to the setup mode in which the error tone

can be made to sound only when the recording tape remainder becomes less

than 5 minutes and when the power supply voltage is erroneous. Details on

the setup numbers are as follows (Initial setting is "01.")

/ /

OE In 01

I'"'PQ' * X ALL

i 01 (*) i ON (Output when BAR LOW, TAPE REMA

I..

'■

1.02.].ON ^joutputonjXw^^^

Table of Contents