Fostex PD-4 Owner's Manual page 53

r
j
REtex
PD-4 DIGITAL AUDIO RECORDER
61)
BATTERY voltage and TAPE remain indicators.
Each block of the battery indicator is about IV in a scale of 9.5V to 16.5V. This indicator
is shown by default.
9.5 10.5 11.5 12.5 13.5 14.5 15.516.5V
''•S \ \
■ ■■■I
/
E
BATTERY
With a 120 minute tape loaded, each block of the tape remain indicator is about 17.5
minutes. To display this indicator, press the BATT/TAPE key (34).
17.5 17.5 17.5 17.5 17.5 17.5 17.5
62) Time code (INT TC, EXT TC, and JAM) Indicators
The INT TC indicator is illuminated when the time code source is the internal
generator.
The EXT TC indicator is illuminated when an external time code signal is present at
the TC IN connector. The indicator will flash if you selected EXT RUN with the
TC GEN MODE selector switch (6) and no time code is detected at the TC IN
connector.
The JAM indicator is momentarily illuminated when the PD-4 is synchronized to external
time code.
63) Level meter
These pair of 18 segment level meters show the signal levels being input in record
mode or the levels being output in playback mode. The meters are peak hold type.
Peak signals are held for approximately 0.5 seconds.
The OVER segment illuminates when the signal level is too high to encode to digital
correctly. Distortion results if this indicator illuminates.
64) Reference level (12dB) indicator
65) DIGITAL indicator
This indicator illuminates when the INPUT switch (3) is set to DIGI (digital) and a
digital signal is present at the DIGITAL IN connector. The indicator flashes if a digital
signal is not detected at the DIGITAL IN connector.
Controls & Connections
21