Sony DTC-670 Operating Instructions Manual page 32

NET a (olUi-m ad t- hg ey-Ced @@) el-ve-ltrelars
Designating the Desired Selection
1 During stop mode, designate the desired program
number with the numeric button(s) on the remote
commander*.
PGM NO.
f ao
T |
Current program Designated program
number number
2 Press » (play).
The designated selection is searched for at high speed
and playback starts from the beginning of that
selection.
PGM NO. AMS
b=. 9
4
PGM NO.
;
.
a
Displayed number is 7
advanced to the
ie Goes off
designated number one
by one.
When you press the numeric button(s) during play-
pause mode, the deck enters the pause mode at the
beginning of the designated selection. Press the
ulPAUSE or ® button to resume playback.
32
If an incorrect number is designated
Before pressing the ® button, press the CLEAR button.
The displayed program number will be cleared.
Then designate the correct program number.
Once the » button is pressed, it is impossible to cancel the
designated selection.
Skip Play
For this operation, the skip ID code(s) must be written on
the tape.
This operation can be performed only with the remote
commander.
Press the SKIP PLAY button on the remote
commander.
The SKIP PLAY indicator lights.
During playback, the tape skips to the next start ID
position automatically when a skip ID is detected, and
the playback resumes.
SKIP PLAY
PGM NO.
To stop skip play
Press the SKIP PLAY button to turn off the SKIP PLAY
indicator.
Auto Play: Restarting Playback after Rewinding
While pressing <4, press >.
The tape is rewound to the beginning, and playback
starts automatically.
If the above operation is done immediately after the
cassette is inserted, the auto play operation does not
function. Press ® a few seconds after <4 is pressed.