Sony DTC-670 Operating Instructions Manual page 19

CD Synchronized Recordi
if a Sony compact disc player with a remote commander is
available, you can start playback of the CD player and the
recording of the DAT deck simultaneously, with the remote
commander of the DAT deck.
Position the remote commander so that the signal reaches
the remote sensor of both the DAT deck and the CD player.
To start recording
This function can be performed only with the remote
commander.
1 insert a cassette.
2 insert the disc in the CD player.
3 Press the CD SYNCHRO STANDBY button on the
remote commander of the DAT deck.
Make sure that the DAT deck enters the record-pause
mode and the CD player enters the pause mode.
4 Press the CD SYNCHRO START button on the
remote commander of the DAT deck.
Recording on the DAT deck starts, and about 1 second
later, playback of the CD player starts.
To stop recording
Press the CD SYNCHRO STOP button on the remote
commander of the DAT deck.
Notes
@ Tomomentarily stop recording of the DAT deck and
playback of the CD player simultaneously, press the
HPAUSE buttons on both the DAT deck and the CD
player.
e With the CD synchronized recording, the recording of
the DAT deck and the playback of the CD player should
be started simultaneously. Therefore, to perform the
CD synchronized recording, point the remote
commander to the remote sensor and press the
appropriate buttons correctly.
To control the CD player with the remote commander of
the DAT deck
The following operations are possible:
Playback: Press the lm button twice.
Pause: Press the lf button once.
AMS:Press the ké< or 1 button.
When a desired selection is located using the above
operation, you can start CD synchronized recording.
19