Sony DTC-670 Operating Instructions Manual page 26

When the skip ID is detected during playback, the tape
skips to the next start ID position, and the normal playback
resumes. (See page 20 for details.)
| Writing duringRecording = eMeliaiire) | Writing duringRecording =
—_—
Press the SKIP ID WRITE button at the beginning of
the portion you want to skip later.
The [SKIP ID] and WRITE indicators light momentarily.
The skip ID is written for about 1 second (2 seconds in
the long-play mode) from where you pressed the button.
START ID
lt ol
SKIP 1D
Bweare—
C END ID 4]
| Writing during Playback (The rehearsal function) | during Playback (The rehearsal function)
During playback, skip ID can be written at the desired
position more accurately than during recording. Make gure
that the safety tab of the cassette is at the record-possible
position,
1 During playback, press the SKIP ID WRITE button at
the desired position.
The REHEARSAL indicator lights and the WRITE indicator
flashes, and the portion for 3 seconds to the point where
you pressed the SKIP ID WRITE button, is played back
repeatedly (rehearsal function).
The end of the repeated portion will be the beginning of the
skip ID.
2 Press the <¢4 or »> button to adjust the "repeat
end" point.
The "repeat end" point shifted backward with the <4
button or forward with the » button, by 0.3 of a second.
The indicator at the MARGIN shows how much the "repeat
end" paint is shifted from the point where you pressed
SKIP ID WRITE.
It can be shifted up to 99 seconds backward or forward.
(eo
REHEARSAL polis dig
3 f &
r 1
Poel Fee 5
When you press «# twice
3 After satting the beginning of the skip ID at the desired
point, press the SKIP ID WRITE button again.
The | SKIP ID} indicator lights, and the skip ID is written,
26
Note on the point where a skip ID is written
During rehearsal function, a skip ID will be written at the
end of the repeated portion as illustrated.
Repeated portion Point where you pressed
SKIP (iD WRITE
Selection Selection
Skip ID (1second)
Each time you press Pe —»
a.
ESS SEES]
3 seconds
Each time you 0.3:
The repeated portion is played back 8 times, and the tape
stops.
Make sure that the safety tab of the cassette is at the
record-possible position.
During playback or in the stop mode, press the SKIP
ID ERASE button immediately after the skip ID to be
erased.
The tape is rewound to the nearest skip ID position and
the skip ID is erased.
The ERASE indicator lights while the skip ID is being
searched for and goes off when the skip ID is erased.
[— iD ]
SKIP {D,
EI
C END ID Ed
Precaution
When the skip ID and the start ID are overwritten, the skip
1D will also be erased if the start ID is erased.
Press the START ID ERASE
button.
Start ID, skip ID
Skip ID
Press the SKIP ID ERASE
button.