Sony DTC-670 Operating Instructions Manual page 27

The end ID indicates the last position of the recording or
playback. While recording on the same tape has been done
several times, you can locate the point where the previous
recording terminates quickly, using the end ID.
When the end ID is detected during playback, the playback
stops and the tape is rewound to the beginning
automatically.
Tai Clare melUlalare Mat-xece liars!
1 Press the NPAUSE or 0
REC MUTE button.
Saas
Record-pause mode
nPAUSE
OREC MUTE
sound muted portion is
created for 4 seconds.
Record-pause mode after a
2 Press the END ID WRITE button.
The END ID WRITE indicator lights.
ia 1D ;
SKIP ID
BND ID
ITE—
7
3 Press the PAUSE or > (play) button to release the
record-pause mode.
The "EE" indicator appears on the display.
The end ID is written for about 9 seconds (18 seconds in
the long-play mode). Tape returns to the beginning of the
end ID after the end ID is written.
PG@M NO.
E
aN
N
After you write an end ID
The portion after the end ID position cannot be played
back. (The "EE" indicator appears at the PGM NO. display.)
Erase the end ID (page 28) where you want to play back
the portion after the end ID position.
Writing during Playback (The Rehearsal Function)
During playback, no end ID can be written on a blank
section.
Towrite the end ID just before a blank section with the end
search function, perform "Writing during Recording"
described on the left colums.
Make suré that the safety tab of the cassette is at the
record-possible position.
During playback, press END ID WRITE at the desired
position.
The REHEARSAL indicator lights and the WRITE indicator
flashes, and the portion for 3 seconds to the point where
you pressed the END !D WRITE button, is played back
repeatedly (rehearsal function).
The end of the repeated portion will be the beginning of the
end ID.
Press the << or »> button to adjust the "repeat end"
point.
The "repeat end point is shifted backward with the <<
button or forward with the m button, by 0.3 of a second.
The indicator at the MARGIN display shows how much the
"repeat end" point is shifted from the point where you
pressed the END ID WRITE button.
It can be shifted up to 99 seconds backward or forward.
=
Re aie
pereansi— [~ SX
8 [aes }
fr END 10 7
WRITE —
7
When you press > twice
After setting the beginning of the end ID at the
desired point, press the END ID WRITE button again.
The "EE" and WRITE indicators light, and an end ID
is written.
Note on the point where an end ID is written
During rehearsal function, an end ID is written at the end of
the repeated portion as illustrated.
Repeated portion
Each time you press
a
Point where you pressed
END ID WRITE
Selection
Selection
End ID (9 seconds)
3 seconds
Each time you press > —>
0.3
The repeated portion is played back 8 times, and the tape
stops.
2/