Sony DTC-670 Operating Instructions Manual page 10

KolsValduitale Max-laccw-lave mOxelaligel ts
Front Panel/Remote Commander
DISPLAY MODE button
Changes the display mode. (Refer to page 12.)
Numeric buttons (0-9)
Designate the desired program number to be played
back before starting playback.
Designate the desired number in the record-pause
mode, the program number is written consecutively
from the designated number.
[20] CLEAR button
Use to cancel the program number which has been
mistakenly entered.
21] MUSIC SCAN button
Use this feature to listen to the beginning of each
selection successively.
22] RMS play buttons
ENTER: To program the selections in a desired order,
press this button after pressing the numeric buttons.
CHECK: Press to check the programmed contents.
REPEAT 14/ALL button
Press to play a desired portion repeatedly. Each time you
press the button, the indicatior changes as follows:
REPEAT 1 -» REPEAT ALL -> off
10
MARGIN RESET button
Press to reset the margin of peak level,
SKIP PLAY button
Press to activate the skip ID code function. The portion of
the tape previously marked will be skipped.
CD operation buttons
Operative only for the Sony CD player equipped with a
remote commander.
ll (pause): Press this button twice to start playback. To
enter the pause mode, press this button once.
k¢<q/m 1 (AMS): Press to locate the desired selection on
the Compact Disc during playback or in the stop mode.
CD SYNCHRO (CD synchronized recording) buttons
(The playback of the Sony CD player equipped with a
remote commander and the recording of the DAT deck
can be performed simultaneously.)
STANDBY: Press to set the unit to the record-standby
mode.
START: Press to start recording of the DAT deck and
then playback of the CD player.
STOP: Press to stop the DAT deck recording and the CD
player playback.