Motorola MOTOKRZR K3 Service Manual page 39

Hide thumbs Also See for MOTOKRZR K3:

Table of Contents

Level 1 and 2 Service Manual

6809509A88-O

Use the plastic tweezers to carefully lift the flip PCB assembly away from the

flip housing (see Figure 22).

Figure 22. Removing the Flip PCB Assembly

To replace, align the flip PCB assembly to the flip assembly.

Carefully lower the flip PCB into the flip assembly. Avoid damaging any of the

display assembly components.

Align the flip display flex to the flex connector on the flip display assembly and

gently press the flex connector into its socket until properly seated.

Replace the flip assembly cover, flip assembly bezel, transceiver board, rear

housing, SIM, battery, and battery connector as described in the procedures.

February 02, 2007

Plastic tweezers

Flip PCB assembly

Disassembly

070094o

Table of Contents

Troubleshooting