Motorola MOTOKRZR K3 Service Manual page 27

Level 1 and 2 Service Manual
6809509A88-O
3. Use the disassembly tool to unseat the display flex connector from its socket
on the transceiver board assembly (see Figure 8).
Transceiver PCB assembly
Figure 8. Removing the Flex Connector
4. Use the disassembly tool to lift the transceiver board assembly out of the front
housing.
Transceiver PCB assembly
Figure 9. Removing the Transceiver PC Board Assembly
5. To replace, place transceiver board into the front housing. Tip the PCB in on
an angle, first inserting the side with three side switches. Take care to clear
the side keys with the PCB or damage will result. Slowly angle the PCB until
it is flat in the housing. The top of the PCB must fit around the screw bosses
of the front housing.
February 02, 2007
Display flex connector
Disassembly tool
Disassembly
Disassembly tool
065330o
070025o
27