Table of Contents
Advertisement
SEBU9077-02
Alternator Pulley - Check
1. Isolate the electrical supply to the engine.
Illustration 35
Typical example
2. Remove the guard (3) to gain access to the drive
pulley (1) for the alternator (2).
Illustration 36
Typical example
3. Tighten the grub screws (4) to a torque of 22 N·m
i08253390
(195 lb in).
4. Install the guard (3).
5. Restore the electrical supply to the engine.
Battery - Replace
Batteries give off combustible gases which can
explode. A spark can cause the combustible
gases to ignite. This can result in severe personal
injury or death.
Ensure proper ventilation for batteries that are in
an enclosure. Follow the proper procedures in or-
der to help prevent electrical arcs and/or sparks
near batteries. Do not smoke when batteries are
serviced.
The battery cables or the batteries should not be
removed with the battery cover in place. The bat-
tery cover should be removed before any servic-
ing is attempted.
Removing the battery cables or the batteries with
the cover in place may cause a battery explosion
resulting in personal injury.
g06018298
1. Check the condition of the battery with a suitable
battery tester.
2. Switch the engine to the OFF position. Remove all
electrical loads.
3. Turn off any battery chargers. Disconnect any
battery chargers.
4. The NEGATIVE "-" cable connects the NEGATIVE
"-" battery terminal to the NEGATIVE "-" terminal
on the starting motor. Disconnect the cable from
the NEGATIVE "-" battery terminal.
5. The POSITIVE "+" cable connects the POSITIVE
"+" battery terminal to the POSITIVE "+" terminal
on the starting motor. Disconnect the cable from
the POSITIVE "+" battery terminal.
Note: Always recycle a battery. Never discard a
battery. Dispose of used batteries to an appropriate
g01233693
recycling facility.
6. Remove the used battery.
61
Maintenance Section
Alternator Pulley - Check
i09652189
Advertisement
Chapters
Table of Contents
