Engine Oil And Filter - Change - Perkins 4008-30 Operation And Maintenance Manual

78
Maintenance Section

Engine Oil and Filter - Change

• The number of hours that have accumulated since
the last oil change
• The amount of oil that has been added since the
last oil change
Ensure that the container for the sample is clean and
dry. Also ensure that the container for the sample is
clearly labelled.
To ensure that the sample is representative of the oil
in the crankcase, obtain a warm, well mixed oil
sample.
To avoid contamination of the oil samples, the tools
and the supplies that are used for obtaining oil
samples must be clean.
The sample can be checked for the following: the
quality of the oil, the existence of any coolant in the
oil, the existence of any ferrous metal particles in the
oil and the existence of any nonferrous metal
particles in the oil.
Engine Oil and Filter - Change
Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot components to
contact the skin.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Do not drain the engine lubricating oil when the
engine is cold. As the engine lubricating oil cools,
suspended waste particles settle on the bottom of the
oil pan. The waste particles are not removed with
draining cold oil. Drain the oil pan with the engine
stopped. Drain the oil pan with the oil warm. This
draining method allows the waste particles that are
suspended in the oil to be drained properly.
Failure to follow this recommended procedure will
cause the waste particles to be recirculated through
the engine lubrication system with the new oil.
Oil and Filter Change Intervals
The standard engine oil and filter change period is
500 hours. There are several other factors that can
alter the standard engine oil and filter change of 500
hours.
• If the engine is using engine oil analysis to
determine oil and filter change period.
• The engine is working in a severe service
environment/Load Factor
• Infrequent operation of the engine
Refer to this Operation and Maintenance Manual,
"Severe Service Application" for more information on
reducing the engine oil and filter change period. For
severe service applications the recommended oil and
filter change period is 250 hours.
i07198738
If the engine is operated in severe service conditions,
Perkins recommends the use of engine oil sampling.
Refer to this Operation and Maintenance Manual,
Engine Oil sample - Obtain for more information.
If the engine is operated infrequently less than 500
hours in a 12-month period, then the engine oil and
filter change should be conducted yearly.
Drain the Engine Lubricating Oil
Operate the engine so that the lubricating oil is warm,
then stop the engine. Isolate the electrical power to
the stater.
SEBU9077-02