Table of Contents
Advertisement
EXCELL PRECISION CO., LTD.
To read software seal event counter:
When switching on the scale, the software seal event counter will show up as C XXX,
where XXX is 0~999.
Note: SWA1 of the scale is in LOCK position.
Rule for the verification seal:
The verification seal is valid when the event counter sticker affixed to the scale matches
the scale‟s software seal event counter. Otherwise the verification seal is broken.
To access service mode via password:
Ensure software seal function is enabled and SWA1 is in LOCK position.
Switch on the scale. During scale countdown, press and hold
countdown has finished, the display will show "PW". Press
"002011", then press
following operations can be performed:
Event counter increment and seal breakage:
If Software Seal is used (where CFn 06 = 1), when entering service mode (any of the 01
CSP, 02 CAL, 03 CLn, 04 CFn, 06 CGr), it will prompt "SurE n" or "SurE Y". If "SurE Y" is
selected, after press
increase by 1. Correct event counter sticker has to be affixed; otherwise, seal is
considered broken.
3-5 Local Gravity Setting
Press
key
Enter the gravity value of
the customer‟s location.
Press
key
The gravity value should be among the value of Equator and Polar.
Acceleration of gravity at the Equator: G
Acceleration of gravity at the Poles: G
Taipei ≒ 9.78914 m/sec
020359XX
key to confirm. Then you can enter service mode, and the
key, it will enter service mode and the event counter number will
.
.
E
= 9.8321772792 m/sec
P
2
Shanghai ≒ 9.79423 m/sec
41
key Upward key (from 0 to 9)
key Downward key (from 9 to 0)
key Move the cursor to right
key Move the cursor to left.
= 9.7803184558 m/sec
key, then after
key. Enter the password
2
2
2
ZSME300000434
Advertisement
Table of Contents
