Attaching the Cables
1. Attach the control/power cables to the side of the positioner. (Fig. 1)
2. Connect the USB cable and white cable from control cable to USB
interface, DO NOT connect to PC yet. (Fig. 2)
3. Connect power supply to power cable (Fig. 3)
4. Connect precision RF cable to positioner. Tighten but do not over-torque. (Fig. 4)
5. Connect other side of RF cable to ports 1 or 2 of test equipment. (Not shown)
x100 Installation & Configuration
Fig. 1
Fig. 3
20
Fig. 2
(ACTUAL UNIT MAY VARY)
Fig. 4