Usb Driver Installation & Configuration - Diamond Engineering DAMS 000 Series User Manual

USB Driver Installation & Configuration
Installing the USB Driver
Antenna Measurement Studio should be installed before performing the steps below.
1. Connect DAMS Platform Controller to PC using included USB cable. Notification
indicating a new device has been found should appear. Allow windows to check
for a driver automatically. If no internet connectivity or Windows cannot
find driver, still proceed with steps 2-5.
2. Check the box labelled "Search Manually" and click "Next".
3. Select CD-ROM, click "Next"
4. Notification may appear that driver has not passed the WHQL certification. Click
"Continue Anyway". Click Finish.
5. New notification indicating another device has been found should appear. Allow
Windows to search for a driver if it was successful the first time. If not, repeat steps
2-5 above.
6. Open up Control Panel (Start→ Settings → Control Panel), and open System. (If
using category view, you must click "Performance and Maintenance" before you can
open System). Open the Hardware tab and click on "Device Manager"
7. Click the "+" sign next to "Ports COM&LPT", and the controller will listed as "USB
Serial Port". Make note of the port number it shows.
Configuring DAMS Software for x250 Series Positioners
1. In Antenna Measurement Studio, click "Positioner Settings".
2. Select the x100 series from the "Interface" pull down menu.
3. Select the COM port that you previously noted from the "Port" pull down menu.
4. Under the x100 pull down menu, select your model.
5. Set "Gear Ratio" to 10.
6. Change "Motor Res." to 1
7. Press the "SAVE" and "QUIT" buttons to save settings and quit.
x250 Installation & Configuration
IMPORTANT: If you ordered a pre-configured PC, you do NOT need to perform
any of these steps unless you are re-installing the system.
38