Software Installation & Configuration - Diamond Engineering DAMS 000 Series User Manual

Software Installation & Configuration
Software Installation
IMPORTANT: Administrator privileges are required to install software.
1. Insert USB Drive into PC, Launch Setup.exe from flash drive
2. Click Next/OK through all setup screens.
3. Agilent Runtime and I/O libraries Setup may also launch. If so, install as well.
4. To verify installation is complete click Start Menu → Programs and ensure
the folders below are present. If so, you may launch Antenna Measurement Studio.
- Agilent Vee Pro Runtime 8.0
- Agilent I/O Libraries
- DAMS
NOTE:
Manually Installing Runtime / IO Libraries
Antenna Measurement Studio is dependent on the application below. It is normally
installed during setup, but can fail in certain situations. In this event, run this setup file
individually:
Agilent I/O Libraries
Entering Your License Key
1. In main screen of DAMS software, at the top of the screen, press "system options"
and "License Information", NOT Simulator License
2. Enter the license key located on the Flash Drive Baggie or from the front or back of
the users manual itself. Press "Verify and Save".
3. Notification key has been verified should appear. Next, click "QUIT" and restart the
software to update the license.
License Problems?
E-mail us at Support@DiamondEng.net or call (530) 626-3857 Monday - Friday, 9:00
A.M. to 5:00 P.M. (PST).
If any folders are missing, an installation error occurred - manually install
components by following instructions below.
Start Menu → Run c:\DAMS\runtime\iolib\Setup.exe
(or launch from CD menu)
25
x100 Installation & Configuration