Chapter 5. Wlr 8900/8905 Setup & Configuration - Wasp WLR8900 Programming Manual

Chapter 5
Setup & Configuration
In order to configure Wasp WLR 8900/8905 Scanners, you must familiarize
yourself with the setup procedures on the following pages. The default settings
of the Wasp WLR 8900/8905 Scanners are identified on each page and clearly
marked using an asterisk (*). The default settings have been preprogrammed
for the most common bar code configurations. Use the Setup &
Configuration only to customize the Wasp WLR 8900/8905 Scanners
settings. If you need to configure the scanner, the default settings will be
overwritten. All the programmed settings are stored permanently in non-volatile
memory; therefore, your configuration will be maintained even if the keyboard
power to Wasp WLR 8900/8905 Scanners is removed by turning off your PC.
In order to configure Wasp WLR 8900/8905 Scanners, two basic steps need
to be followed:
(1) Locate the group that contains the options to be changed.
(2) Scan the bar code representing the option to be changed. The scanner will
sound two beeps.
To change Minimum/Maximum Length:
(1) Scan the Minimum or Maximum Length bar code.
(2) Scan a 2 digit value from the ASCII table on pages 31-34
(3) Scan the Minimum or Maximum Length bar code again.
Example: To have a minimum length bar code of 1, you must scan a 0 then 1, then scan
the minimum bar code again. To have a maximum length bar code of 10, you must scan
a 1 then 0, then scan the maximum bar code again.
5