Sony WEGA KLV-32M1 Operating Instructions Manual page 30

Connecting a DVD Player with S Video and Audio
Connectors
Use this hookup if:
° Your DVD player does not have component (Y, PB, PR).jacks.
Tips
• If your DVD player has component video output connectors, for best picture quality, use the
connection described on page 29.
• The Y, PB and PRjacks on your DVD player are sometimes labeled as Y, CB and Ca, or
Y, B-Y and R-Y. If so, connect the cables to the snatching colors.
• To take advantage of the Wide Screen Modes, set the aspect ratio of the output signal to
16:9 on your DVD player. For details, refer to the operating instructions supplied with your
DVD player.
Disconnect all power sources before making any connections.
1
Using an A/V cable, connect the DVD player's AUDIO OUT.jacks to the
TV's AUDIO IN jacks.
2 Using an S VIDEO cable, connect the DVD player's S VIDEO OUT.jack
to the TV's S VIDEO IN jack (VIDEO 1 IN or VIDEO 3 IN).
Tip
If your DVD player is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of
the S VIDEO cable.
Rear of TV
AN cable --
(not supplied)
a,_ VIDEO (yellow) --
"" _ S VIDEO ..................................
SV,D
EO cable
Y_ (not supplied)
AU R A L V_:O
@®©
DVD Player
VIDEO tN
D rAUOlon VIDEO SWDEO
¢
d
¢
??
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, snake sure
"Auto YC" in the _ (Setup) menu is set to "On" to view the S VIDEO input (see 25). page
Tips
• You can also use the VIDEO 2 IN jacks located on the front of the TV to connect your
DVD player.
• Use VIDEO 1/2/3 on the remote control to switch to the DVD player input.
3O