Sony WEGA KLV-32M1 Operating Instructions Manual page 25

Connecting a VCR and Cable TV
Use this hookup if:
• You subscribe to a cable TV system that does not require a cable box.
75-ohm
coaxial cable
(supplied)
VCR IrJ t
<..:0oo°A00.o<v.oEo sv, @
SV,DEOcab,e
.. (not supplied)
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the VCR's IN jack.
2 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT,jack
to the TV's VHF/UHF jack.
3 Using A/V and S VIDEO cables, connect the VCR's AUDIO and S VIDEO
OUT jacks to the TV's AUDIO and S VIDEO IN jacks (VIDEO 1 IN or
VIDEO 3 IN).
Tip
If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
2
75-ohm coaxial
cable (supplied)
Rear of TV
1 r AUOEOq VIDEO SVlDEO
......... Y :............
?
g_ ; 7 / ; )
Vl0EO ,,e,ow)= ;
/_u_o:3 ......................... ,/
s
VIDEO
©
O
o
5
t_
o..
00
-4
<
AN cable (not supplied)
Note
,,,When you,,cormect video equipment to both the VIDEO and the S VIDEO input jacks, make sure
'Auto YC in the _j_ (Setup) menu is set to "On' to view the S VIDEO
input
(see below).
Tip
You can also use the VIDEO 2 IN jacks located on the l]cont of the TV to connect your VCR.
When connecting both VIDEO IN and S VIDEO IN
Using the melm, you can select the :jack from which the TV receives the input
signal. You can set it for each video input (VIDEO 1 IN, VIDEO 2 IN and
VIDEO 3 IN) separately. The TV is tilctory set to receive S VIDEO input signals.
1 Press VIDEO 1/2/3 repeatedly until the desired video input appears.
2
Press MENU.
3 Press tl,/!1,to select _ (Setup), then press
GD.
4 Press tl,/II, to select "Auto YC," then press (Z).
5 To watch the pictures input from the S VIDEO input,jack:
Press tl,/II, to select "On," then press (]Z).
To watch the pictures input from the VIDEO input ,jack:
Press tl,/II, to select "Oft," then press (Z).
6 Press MENU to exit the menu screen.
25