Sony WEGA KLV-32M1 Operating Instructions Manual page 26

Connecting a Satellite Receiver
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2 Using A/V and S VIDEO cables, connect the satellite receiver's AUDIO and
S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks (VIDEO
1 IN or VIDEO 3 IN).
Tip
If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
3
Connect the supplied 75-ohm coaxial cable from your cable or antenna to the
TV's VHF/UHF.jack.
Satellite
antenna
cable I '1
Satellite Receiver
_-- SATELL,T_
l S VIDEO I
#_ cable
.."
(not supplied)
A/V cable (not supplied)
"41
75-ohm coaxial v
cable (supplied) _ V _l
VIDEO
IN
1j r-AUmon V_DEO SVIDEO
VIDEO (yellow)f !
S VIDEO .......
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
,, ,,
sure "Auto YC ' in the _ (Setup) menu is set to "On' to view the S VIDEO input (see page
25).
Tips
• You can also use the VIDEO 2 IN jacks located on the front of the TV to connect your
satellite receiver.
• Use VIDEO 1/2/3 on the remote control to select VIDEO 1 IN (or VIDEO 3 IN if you use
the VIDEO 3 1N jacks for this hookup) to watch satellite TV.
26