Sony WEGA KLV-32M1 Operating Instructions Manual page 27

Connecting a Satellite Receiver and a VCR
Satellite Receiver
SVIDEO AUDIOR AUDIOL Vl_O
S VIDEO cable
(not supplied)
VCR
3
75-ohm coaxial
cable (supplied)
Disconnect all power sources before making an 3, connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2 Connect the CATV cable to the VCR's VHF/UHF IN jack.
3 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack
to the TV's VHF/UHF jack.
4 Using A/V and S VIDEO cables, connect the satellite receiver's AUDIO
and S VIDEO OUT jacks to the VCR's AUDIO and S VIDEO IN jacks.
Tip
If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
5 Using A/V and S VIDEO cables, connect the VCR's AUDIO and S
VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks (VIDEO
1 IN or VIDEO 3 IN).
cable
.............. _V
cable
supplied)
A/V cable
(not supplied)
75-ohm coaxial
cable (supplied)
VIDEO IN
1j r-AUDIOn VIDEO SVIOEO
i
• , oo
VIDEO (yellow) ....................... j
S VIDEO
cable
(not supplied)
©
O
o
5
t.Q
O._
09
t Q
G)
-4
<
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure
'Auto YC' in the _ (Setup) menu is set to 'On to view the S VIDEO input (see page 25).
Tips
• You can also use the VIDEO 2 IN jacks located on the front of the TV to connect your VCR.
• Be sure your VCR's video input is set eon'ectly. Consult your VCR's operating manual for
instructions.
• Use VIDEO 1/2/3 on the remote control to select VIDEO 1 IN (or VIDEO 3 IN if you use
the VIDEO 3 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be tumed on).
27