Sony UP-890CE Service Manual page 7

1-5. BEFORE PRINTING
LLL aaa OT Ee A eT
Setting the Type of Paper Setting the DIP Switches
Set the PAPER TYPE selector to the type of paper to be used. Set the DIP switches according to the required print mode. Before setting the DIP
'The use of paper other than Sony may result in reduced printer performance and switches, turn the power off, Change the settings using a small pointed tool such as
poor print quality.
a small screwdriver. The factory settings are as follows.
Type of paper PAPER TYPE switch position
UPP-110S | (Normal)
UPP-110HD Il (High density)
UPP-110HA !V (Enhanced)
on
Parti oor
AtMore i onew NN
i
APER
P
<-viDEO— GAMMA TYPE
Louw Luv
SW-ON|SW-OFF
O OFF
FEED [ON [OFF |
When you set the PAPER TYPE selector to I or IV, set the density gradation with To interrupt the printing under way and print a new picture when you press
the GAMMA selector. the PRINT button during printing, set this switch to ON.
1: Soft gradation To disregard that the PRINT button is pressed during printing and continue
Hi: Standard the printing under way, set to OFF.
IV: Hard gradation If you press the PRINT button during printing in OFF mode, the alarm buzzer
will sound.
[2] POSTFEED ON/OFF switch
To feed out extra blank paper once a picture has been printed, set this switch
to ON.
To save paper by feeding only a short length of paper after printing a picture,
set (o OFF. You can make more print-outs per roll of printing paper, but you
have to take out and cut the paper yourself,