[WM] To the end of screen printing and stopping
pation
i
ee
a
1c301-@
STB
ae
eee
eee
'
1C301-©
COPYING
1C301-@
COPY-STOP
|
1C301-@
I 1pSec
1C301-@
Ms2
—-
1C301-@
| APPROX.
lIsec
PM FW
1C301-@
ea
a
ee
ee ee
Fig.5-7. End of Screen Printing Timing
Operation
(i) IC103 counts the printing lines and when the specified number of lines have
been printed,
it outputs
a "H"
signal from its 1C103-@ to IC301-@, which
tells IC301
that the printing operation has ended
and it outputs
the COPY-
STOP pulse.
*Note: The COPY-STOP
pulse is also output even if COPYNING
is "L", if IC
301 judges that something abnormal has arisen. In such a case, when this
COPY-STOP
pulse is input to IC103, it sets COPYING
"II".
This
characteristic
can
be
used
to
analyze
any
problem
that
causes
printing to stop. If COPY-STOP
was issued while COPYING
is "L", the
cause is related to IC301 screen printint is then stopped. If COPY-STOP
was issued while COPYING
is "H", the cause is related to IC103.
(ii) After the COPY-STOP
pulse, MS1, MS2 are changed to fast forward for about
1 second, then PM FW
is set "H" to stop.
Reverse the Head U/D motor (IC301-©,
@: "L","If") and check that the
Head goes up (1C301-69, @: "II","L"). Then stop the motor.
(1C301-@,
@: "H","H").
5-4-3. Mode set
No. 1 through 4, 6 through 10 of DIP switch S302 on the rear panel are input to
1C301 to select each screen printing mode.
The mode set is input from 1C301-@
to IC103-@0 in serial data format when the PRINT key and COPY key are pressed.
Each screen printing mode cannot be selected during screen printing.
—54—