Sony UP-890CE Service Manual page 11

14
To print in SMALL mode
Press the PRINT button twice, When you press the PRINT button once, the buzzer
sounds. The printer starts printing after the PRINT button is pressed twice.
Stopping printing midway
Press the OPEN/CLOSE button while printing or while copying. The printer stops
printing.
To stop printing and print another picture displayed on the video
monitor
To do this, the DIP switch fil (INTERRUPT) must be set to ON (p. 7).
Press the PRINT button while printing or copying. The printer stops printing and
starts printing the picture displayed al the instant you press the PRINT button.
Making copies of the last print-out
Operation
Press the COPY button. The printer makes a copy of the last print-out. The last
print-out is retained in the printer's memory until you press the PRINT button
again or turn the power off.
To copy in different sizes
You can copy the last print-out in different sizes.
Before pressing the COPY button, select the printing size as described in
"Selecting the Printing Size".
* If you press the COPY button immediately after turning the power on, the alarm
buzzer will sound as nothing is stored in memory.
* In SMALL mode (p. 13), if you press the COPY button after you have pressed
the PRINT button only once, the alarm buzzer will sound and the printer will not
copy.
To make multiple copies of the same print-out
Press the COPY button as many times as necessary (maximum 1} copies including
the fitst print-out) while printing or copying the first print-oul. Each time you press
the COPY button, the short buzzer sounds.
To stop copying midway
Press the OPEN/CLOSE button.
Adjusting the Contrast and Brightness
You can adjust the contrast and brightness of the print-out.
1 Sct the THRU/EE selector to EE.
You can check the adjusted picture on the video monitor.
CONTR BRIGHT
2 Adjust the brightness with the BRIGHT control and the contrast with the
CONTR control while watching the picture on the video monitor.
Adjusting the contrast
CONTR
Weaker (@) Stronger
Adjusting the brightness
BRIGHT
Darker Brighler
To directly input the video signal from the video equipment, which is
connected to the printer, to the video monitor
Set the THRU/EE selector to THRU. The video signal is directly input to the video
monitor without being processed by the printer's circuitry.
Operation | 15