Programming; Installer Menu; Pv Mode - Dimplex 200 AIR D/2 Installation Manual

5.8 - Programming

m on day
day
ne w PRoG.
C OPy DIM.
C OP y PR OG.
M O DI F y PR G.
se e PRO G.
• Press to return to the main menu.

5.9 - Installer menu

It may be necessary to adjust certain temperature settings to
optimise the performance of the
depending on how the appliance is installed.
Accessing the installer menu:
• Press
• Turn the dial until the screen displays
installer menu.
« »
Clock settings
• Press the «
Menu simultaneously
« » buttons
Keep both buttons pressed down
•

pv mode

screen displays «
MODE PV
To activate photovoltaic operation
settings
To adjust the installation settings
display
To display temperatures of sensors
and inlets
-
INSTALLER
Programming enables you to define the periods of time the appliance runs in
«Economy», «Comfort» or «Frost protection» modes. The electrical back-up is not
Select day
allowed to run when the appliance is in «Economy» mode.
• Press"Clock settings"
0 0 0 0 - __ __
0 0 :3 0
h
Set end of fi rst
time slot
= Copy programming from the previous day
= Copy a standard program or
programming from another day
= Modify existing programming
= See existing programming
heat pump water heater,
» and
for 3 sec. until the
»
reset par.
To go back to default settings
counters
To set the meters running, count
start-ups, etc.
HEAT PUMP WATER HEATER 200 -270L AIR D/2 -
and hold down for 3 seconds.
00 00-0 6 30
f r o s t p t
Set comfort level for
the fi rst time slot
Heating time for the tank varies
according to exterior temperatures.
Ensure that the operating time of the
appliance is not too limited.
f r o s t p t
E C O
=
C O m F
=
5.9.1 - PV mode
Parameter Description
mode p v Activation of
photovoltaic mode
priority Interval of anti-
legionellosis cycles
1. If the PV mode regulator is connected to connectors 1 and 2 on the
electronics board, PV mode must be activated.
• The electrical energy which is produced is stored in the form of
hot water. The PV function can be set to two diff erent levels of
production.
• PV ECO = the lower level of the photovoltaic energy production.
The heat pump generates a higher water temperature. The hot
water temperature must be somewhere between the regular hot
water temperature and 60°C (factory setting = 60°C).
• PV MAX = the higher level of photovoltaic electricity production.
The heat pump and electrical back-up generate a higher water
temperature. The hot water temperature must be somewhere
between the eco mode hot water temperature and 65°C (factory
setting = 65°C).
2. Turn the dial to set the mode:
- Menu → INST. MENU → PV mode.
3. Select « Yes »
4. Press the dial to confi rm.
5. Press Menu.
6. Set the domestic hot water temperature.
0 63 0- _ __ _
0 6: 3 0
h
Set end of second
time slot
...and so on, up to 7 time periods
per day until 24:00.
Legend
= Fros t protecti on mod e
H e a t p u m p a l o n e r u n n i n g
H e a t p u m p a l o n e r u n n i n g
+ el ectr i cal back- up w h en ne e de d
Unit Time
range
- yes
no
- yes
no
-
MANUAL
Factory
setting
no
yes
15