Safety - Dimplex 200 AIR D/2 Installation Manual

Preserving these documents
• This manual and all other relevant documents should be given to
the system user.
The system user should keep these manuals for future reference.

1 - SAFETY

• Any intervention on the
thermodynamic water heater should
only be performed by qualifi ed personnel.
• Follow the safety instructions!
• Any intervention on the refrigeration circuit
must be made by a qualifi ed person who
holds a Category 1 certifi cate of fi tness.
Refrigerant R290, contained in the heat pump
circuit, does not pose an environmental
hazard but is fl ammable.
Refrigerant R290 is odorless.
do not damage the refrigeration circuit tubes,
do not handle fl ame or other fl ammable
sources inside the device,
in the event of a leakage of the refrigerant,
unplug the plug, ventilate the room and
contact the customer service,
Do not pierce or burn the appliance: the
recovery of the fl uid is mandatory in case of
intervention on the refrigeration circuit.
Danger of death by electrocution
Touching live electrical wires can cause
severe injury.
• Before undertaking any work on the
appliance, ensure to switch off the power
supply to the appliance.
• Ensure that there is no possibility of the
power supply becoming active again.
Danger of injury or death due to the
absence of, or defective, safety devices.
Absence of safety devices can be dangerous
and may result in burns or other injuries.
Injuries could be caused by pipes bursting
for example.
The information provided in this document
does not represent all of the diagrams
required for a professional installation of
the safety devices.
• Install all required safety devices in the
circuit.
• Inform the user of where the safety devices
are placed, and how they work.
• Follow all relevant national and
international health and safety rules and
regulations.
-
INSTALLER
HEAT PUMP WATER HEATER 200 -270L AIR D/2 -
Danger resulting from improper use
Any work carried out by an unqualifi ed person
can result in damage to the installation or in
physical injury.
• Do not perform any maintenance work on
this appliance unless you are a qualified
professional.
Intended use and applicable areas of use
This appliance is intended for use as an
appliance for domestic hot water production.
The intended use of the appliance includes
the following points:
• following the instructions for operating,
installing, and maintaining this appliance
and all other parts and components of the
system.
• ensuring the compliance with all conditions
of inspection and maintenance which are
listed in this manual.
Humidity and water splashes
The appliance should be installed in an area
where it is not exposed to humidity and
without risk of being splashed by water.
Rules and regulations (directives, laws, and
standards)
Once the appliance is installed and switched
on, all decrees, directives, technical rules,
safety measures and standards, must be
respected in their current version in eff ect.
• This appliance should not be used by: children
under 8 years old; anyone with reduced
physical, sensory or mental capabilities; or
by anyone who has insuffi cient experience
or knowledge of the appliance; unless
they are being supervised by someone
who is responsible for their safety and in
possession of the operating instructions of
the appliance.
• Children should be supervised to ensure that
they do not play with the appliance.
• Cleaning and maintenance of the appliance
should not be undertaken by children
without proper supervision.
A method of disconnection ensuring a
complete cut-off according to Category
III conditions must be installed in the fi xed
piping to conform to installation regulations.
-
MANUAL
3