僅 Resetting The Sunroof - Kia Niro Owner's Manual

Features of your vehicle
opened, closed, or tilted. Damage to
the sunroof motor could occur.
僅 Continuous operations such as slide
open/close, tilt open/close, etc. may
cause the motor or sunroof system to
malfunction.
僅 Regularly remove any accumulated
dust on the sunroof rail.
僅 Dust accumulated between the sun -
roof and roof panel can make noise
Open the sunroof and remove dust
regularly using a clean cloth.
僅 Do not try to open the sunroof when
the temperature is below freezing or
when the sunroof is covered with
snow or ice. The sunroof may not
work properly and may break if
opened by force.
僅 Do not open or drive with the sunroof
glass open immediately after rain or
washing the vehicle. Water may wet
the interior of the vehicle.
僅 Do not extend any luggage outside
the sunroof whilst driving. Vehicle
damage may occur if the vehicle sud -
denly stops.
WARNING
Do not extend your head, arms, body
parts or objects outside the sunroof
whilst driving. Injuries may occur if the
vehicle suddenly stops.
5 40
Resetting the sunroof
OSG2H041073
In some circumstances resetting the
sunroof operation may need to be per -
formed. Some instances where resetting
the sunroof may be required include:
僅 When the 12-volt battery is either dis -
connected or discharged
僅 When the sunroof fuse is replaced
僅 If the sunroof one-touch AUTO OPEN/
CLOSE operation is not functioning
properly
Sunroof resetting procedure:
1. It is recommended to perform the
reset procedure with the vehicle
engine running. Start the vehicle in P
(Park).
2. Make sure the sunroof glass is in the
fully closed position. If the sunroof
glass is open, push the switch forward
until the sunroof glass is fully closed.
3. Release the switch when the sunroof
glass is fully closed.
4. Push the switch forward until the sun -
roof glass moves slightly. Then
release the switch.
5. Once again push and hold the sun -
roof switch forward until the sunroof
glass slides open and close. Do not
release the switch until the operation
is completed.
If you release the switch during oper -
ation, start the procedure again from
step 2.
Sunroof