Door Window; Oven Doors And Bearings (Independent Doors) - Vulcan-Hart VC4EC Service Manual

FULL SIZE ELECTRIC CONVECTION OVEN - REMOVAL AND REPLACEMENT OF PARTS
4. Reverse procedure to install the replacement
switch and check for proper adjustment as
outlined under DOOR SWITCH ADJUSTMENT
in SERVICE PROCEDURES AND
ADJUSTMENTS.

DOOR WINDOW

1. Remove the screws at the top and bottom of
door.
2. Independent doors:
A. Remove the door handle then remove the
outer door panel.
B. Lift out the inner door panel and window
assembly.
NOTE: Left door only - remove door seal from
the inside edge of the door.
3. Simultaneous doors:
F25105 (Rev. A, October 2007)
A. If replacing window on the left door,
remove the handle from the front of the
door then remove door seal from the inside
edge of the door.
1)
2)
4. Remove the screws securing the window "tabs"
to the door bracket and lift the window assembly
out from the door frame.
5. Reverse procedure to install the replacement
window.
OVEN DOORS AND BEARINGS
(INDEPENDENT DOORS)
1. Remove the top front cover and bottom front
cover as outlined under COVERS AND
PANELS.
2. Remove the door switch lever.
Page 12 of 60
Lift out the inner door panel and
window assembly.
If replacing window on the right door,
remove the screws along the inside
edge (if applicable) of the door then
remove the inner door panel and
window assembly.