Oven Door - Vulcan-Hart VCE10F 126179 Service Manual

ELECTRIC COMBI OVEN - REMOVAL AND REPLACEMENT OF PARTS

OVEN DOOR

WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
Removal
1. Remove the left and right side panels as
outlined under "COVERS AND PANELS".
2. Disconnect the lead wires to the lamp on the
power supply board terminal block and route
them so they can be pulled through the hole in
the frame when the door is removed.
3. Support the door, remove the screws from
each hinge block on the oven and remove
door.
4. Reverse procedure to install.
Disassembly
1. Remove the door from the oven as outlined
above in "REMOVAL".
2. Lay the door on a flat surface with the inside of
the door facing up.
3. Lift up along the inner door glass edge near the
door latch and unsnap the glass from the "snap
catches" in the oven door.
4. Open the inner door glass and remove the c-
ring clamps from the rear snap catches, unsnap
at the rear then lift off.
CAUTION: When replacing the inner door glass,
it must be installed with the conductive side
toward the front of the oven. Use an ohmmeter
to verify the conductive side. Set the meter to
read ohms and touch glass with the meter leads.
A resistance will be measured but will vary
depending on the distance between the meter
leads, grease and/or other substances on the
glass.
5. Remove the bolts securing the top and bottom
hinges to the door.
6. Remove the drip tray, remaining screws from
the inner door panel, the screws at the left,
right and bottom of the door and remove the
door handle.
7. Lift the inner door panel from the outer door
frame.
8. Remove the outer door glass.
9. Reverse procedure to install.
10. Adjust the door as outlined under "OVEN
DOOR ADJUSTMENT" in "SERVICE
PROCEDURES AND ADJUSTMENTS".
Page 18 of 68