BMW R 12 nineT 2023 Rider's Manual page 119

Adjusting rebound-stage
damping for front wheel
Prepare the screwdriver from
the on-board toolkit. (
Adjust rebound-stage
damping by turning adjusting
screw 1 on the right fork leg.
To increase damping: Use the
tool from the on-board toolkit
to turn the adjusting screw so
that mark 1 points to a higher
value on the scale.
To reduce damping: Use the
tool from the on-board toolkit
to turn the adjusting screw so
that mark 1 points to a lower
value on the scale.
Rebound stage, basic
setting, front
Position 1 (comfortable set-
ting with rider 95 kg)
Position 5 (normal setting
with rider 95 kg)
Position 8 (sports setting
with rider 95 kg)
Restoring factory defaults at
front wheel
Reset the factory defaults as
155)
stated below.
Factory default settings
for compression/re-
bound stages, front
Position 5
Adjusting damping for rear
wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Prepare the screwdriver from
the on-board toolkit. (
113
155)