Power Cable Size Reduction - Nexus NEO Manual

NEO / NEO WIFI power supply cable cannot be repaired. If it is damaged, it must be
replaced by the manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard. Never try to modify or repair the NEO / NEO WIFI in any of its parts by
yourself. Never try to remove any part of the NEO / NEO WIFI as water can penetrate
inside the regulation box resulting in a risk of electrical shock. Never knock the NEO / NEO
WIFI against anything. Handle with extreme care during every operation and never leave it
in wet areas.
11
POWER CABLE REDUCTION
The length of the power supply cable NEO / NEO WIFI can be reduced to allow its direct
installation in a wall box or connection to a terminal designed for the cable, i.e. it is certified
and rated for the given type of installation (e.g. an electric plug with an integrated switch).
CAUTION! The cable must extend at least 300 mm from the inlet to the heating unit, the
thermostat receiver or regulator (according to the equipment installed) after it has been cut.
No warranty claim or repair will be accepted, including defects not related to the shortening
of the cable, if the length of the cable is less than 300 mm.
The reduction may only be carried out by a person with the appropriate electrical
expertise! The external insulation of the cable and the insulation of individual conductors
must remain intact. Avoid using cables with broken insulation.
All connections/wiring must be in compliance with the legislation of the country where the
installation is performed, as well as with the rules for use in specific environments (e.g.
bathrooms), the IEC 60364-7-701 standard in particular.
In this case, the rated degree of protection, IPX4, as declared by the manufacturer of
the product, will not apply to the reduced end of the cable and/or any terminal.
The wiring of Class I equipment is as follows:
30