Cleaning - Nexus NEO Manual

INSTALLING THE HEATING ELEMENT IN THE TOWEL RAIL
a. Unscrew the heating element from the towel rail with a light rotary movement.
Remove the Nexus connector cover.
b. Insert the supplied NEO / NEO WIFI O-ring gasket from the bottom over the heating
element in the reserved space.
In order to minimize the risk for leakage it is recommended to use a PTFE tape or
similar product to prevent leakage.
c. Insert the tip of the heating element into the bottom hole of the towel rail and make
sure to select the female ½" GAS thread.).
d. Insert the heating element all the way in the upside down radiator and screw in the
heating element using a 25 mm wrench (not included).
In case of 'Dual fuel' installation, a T-piece of 40 mm maximum length (male thread
excluded) is sometimes required.
Insert the T-piece in the heating element, screw and tighten it firmly. Do not use tools.
WHEN THE HEATING ELEMENT IS CONNECTED TO THE TOWEL RAIL, GO TO 5.5.1

5.6 Cleaning

To clean NEO / NEO WIFI, use only a dry and clean soft cloth.
Make small locally round movements.
Apply a light pressure especially to the chrome plastic surfaces to avoid potential scratches.
Do not clean NEO / NEO WIFI with aggressive products.
Do not wet NEO / NEO WIFI in an attempt to clean it. Do not immerse in water.
When cleaning NEO / NEO WIFI, it must be disconnected from the power supply.
Ventil 3 bar
16