Neo / Neo Wifi Position; Towel Rail Position - Nexus NEO Manual

• Make sure that the power lines are appropriate for the load required according to
technical specification tables (see part 4).
• Class I NEO / NEO WIFI (with yellow-green wire or earthed plug) must ONLY be
connected to sockets or connector blocks with earthed contacts according to national
standards and wiring regulations in force
• Protect the electricity supply with an RCCB (Residual Current Circuit Breaker) device.
• The electrical heating element must be connected to a suitable electricity supply by
way of the cable provided. This should be via a fused spur in accordance with the IEE
Wiring Regulations. If sited in the bathroom, the Fused Connection Unit must be
located out of reach of persons using the basin, shower or bath. If in doubt, consult a
qualified electrician.
The socket and electricity supply must be appropriate for the required power. Do not
use extensions.
The socket must be compatible with the NEO / NEO WIFI supply cord plug. Do not use
adapters.

5.4 NEO / NEO WIFI position

NEO / NEO WIFI must be fitted into the towel rail BEFORE mounting the towel rail to the
wall.

5.4.1 TOWEL RAIL POSITION

• Do not install NEO / NEO WIFI into a towel rail fitted in ZONE 0 or ZONE 1 (Zone
definition IEC 60364-7-701 in Figure 3).
• The towel rail must be installed in a completely vertical wall.
• The towel rail has to be mounted parallel to the wall using the brackets recommended
by the towel rail manufacturer.
• NEO / NEO WIFI is protected against water ingress according to its IPX4 degree of
protection. The towel rail where NEO / NEO WIFI is fitted must be mounted inside the
zone of the bathroom according to its IP degree of protection and electrical legislation
in force. In case of doubt about the correct installation zone, refer to the relevant public
institution.
• NEO / NEO WIFI must not be within reach of people using the basin, shower or bath.
NEO / NEO WIFI supply cord
WITH plug
11