Towel Rail Warnings; Power Supply Warnings - Nexus NEO Manual

CONTACTS SECTION.
• When you are ready to start, make sure that you have the right tools at hand, plenty of
space and a clean dry area for assembly.
• Installation must be carried out in accordance with current standards and laws in force
in the country in which the system is installed.
• Before installation, never switch the NEO / NEO WIFI on to verify functioning
effectiveness.
• Don't use the NEO / NEO WIFI regulating box to lean the electrical towel rail on the
floor as you can damage the plastic housing and water can penetrate inside with a risk
of electrical shock.

5.2 Towel Rail Warnings

• The electric radiator with regulator use is intended only for heating rooms in the home.
Any other use is forbidden.
• The heating element must be fitted in the towel rail before mounting the rail to the wall.
• The towel rail has to be mounted parallel to the wall using the brackets recommended
by the towel rail manufacturer.
• It is recommended to use in any installation (Electric only and Dual fuel) a self relief
pressure valve (like a 3 Bar valve) on the top part of the rail in the opposite side where
the NEO / NEO WIFI is installed. In case of valve intervention, it is quite normal for
liquid relief and water excess to possibly reach the floor. Please, take this aspect into
consideration.
• In Electric only NEO / NEO WIFI installation, fill the towel rail with certain percentage of
water according to the towel rail manufacturer instructions. In case of missing
instructions, we recommend to fill the towel rail approximately 90% with approximately
90% pure water and glycol mixture.
• In Electric only NEO / NEO WIFI installation the towel rail must have a sufficient air gap
to allow for water expansion.
• Making sure that the NEO / NEO WIFI heating element is completely immersed in
water.In case of Dual fuel installation, a T-piece of 40mm maximum length (male
thread excluded) is required: we recommend to wrap a small quantity of PTFE tape
around the heating element thread and the T-piece thread.
• All metallic parts of the electrical towel rail fitted with NEO / NEO WIFI and powered
must not exceed the temperature limits according to the applicable standard also in
case of NEO / NEO WIFI continuously powering the electric heating element.
For all other aspects, refer to EN 60335-1 and EN 60335-2-30.

5.3 Power supply Warnings

• Do not connect NEO / NEO WIFI to the power supply until the installation into a
properly filled towel rail is completed.
10