Procedure For Installing The Motor - Siemens SIMOTICS T-1FW6 Operating Instructions Manual

1FW6290-xxB07-xxxx to
1FW6290-xxB15-xxxx
1FW6290-xxB20-xxxx
Note
Friction value
For the contact surface of the screw head and the screw thread, the friction value µ
taken as a basis.
• For smaller friction values, you must reduce the tightening torque and for larger friction
values you must increase the tightening torque.
• Also note the maximum tightening torques of the screws used. These may be lower than the
values specified in the table above.
Table 5-5
1FW6050, 1FW6060 / stator
1FW6050, 1FW6060 / rotor
1FW6090, 1FW6130 / stator and rotor
1FW6150 / stator and rotor
1FW6160, 1FW6190, 1FW6230 / stator
1FW6160, 1FW6190, 1FW6230 / rotor
1FW6290 / stator
1FW6290 / rotor
*) On this topic, see installation drawing "Detail Z"
5.7

Procedure for installing the motor

Sequence for installing the motor
Risk of injury and material damage
Injury and/or destruction of motor components can occur if you do not observe the specified
sequence when installing the motor.
• Perform work steps in the specified sequence during installation.
1FW6 built-in torque motors
Operating Instructions, 09/2022, A5E52220812B AA
Motor
Maximum permissible screw insertion depths for the stator and rotor
Component
WARNING
5.7 Procedure for installing the motor
Screw
(strength class)
M10 (8.8)
M10 (10.9)
max. permissible screw-in depth
in mm
8.5 + section without thread *)
11
10
12
13
12
15
15
Installation
Tightening torque
M in Nm
A
43
61.8
= 0.1 is
tot
Thread
M6
M6
M5
M6
M8
M8
M10
M10
77