Advertisement
DS-L
SERIES
IV. Cause for Failures
Ls
Cause for failures
Contents of disposal
LPS failure
Try again after inputting the EJECT KEY.
pe | Failure when
returning the disc
Le
LPS failure
Try again after inputting the EJECT KEY.
into the magazine
Try again after 100msec, and when the LPS is lower
LPS failure
than 13, it should be so judged that the EJECT has
4. Operation during ACC OFF
been completed.
Disposal of ACC OFF
If the ACC is turned off during the mode conversion, enter into the STAND BY MODE after the
Apply the reverse rotation again, and try again after
detecting the D LOAD switch.
When the inputs of PHOTO 1 and PHOTO 2 can not be
detected, the reverse rotation should be applied, and after
detecting the D LOAD switch, shift to the next disc.
When any of these PHOTOS can be detected, the reverse
rotation should be applied, and try again after detecting
the D LOAD switch.
Failure when
ejecting the disc
timing chart now under execution has been completed.
5. Forced STAND BY operation
Forced STAND BY
If the B-HOLD should be detected during the mode conversion, the timing chart execution should
be promptly interrupted, and shifted to the STAND BY MODE.
Further, when restored, the step which has been executed before the coercive STAND BY should
be executed again.
—~26-—-
Advertisement
