Cisco Firepower 9300 Hardware Installation Manual page 70

Hide thumbs Also See for Firepower 9300:

Table of Contents

Install, Remove, and Replace the Single-Wide Network Module

Figure 43: Remove and Replace the Single-Wide Network Module

If the slot is to remain empty, install a blank faceplate to ensure proper airflow and to keep dust out of the chassis;

otherwise, install another network module.

Step 4

(Optional) If you are installing a single-wide network module into a double-wide slot, you must install a divider. The

blank faceplates are for a single slot, so install the divider if you are covering two single network slots.

The original 9300 chassis and the newer 9300 chassis have different dividers. You can order FPR9K-NM-DIV=,

Note

which contains a screw and both dividers in case you have lost the divider (part number 800-101936-01) for

the older chassis or you need the new divider (part number 700-112465-01) for the newer chassis.

Step 5

To install a new network module, hold the network module in front of the network module slot on the right side of the

chassis with the handle fully extended. Slowly push the module into the network module slot until the handle catches on

the mating feature in the chassis. The handle should engage correctly.

Step 6

Gently push on the handle until it is fully seated on the network module faceplate and the module is fully seated in the

chassis.

Step 7

Tighten the captive screw on the left of the network module.

Step 8

Do one of the following:

Cisco Firepower 9300 Hardware Installation Guide

Installation, Maintenance, and Upgrade

Table of Contents