Cisco Firepower 9300 Hardware Installation Manual page 57

Hide thumbs Also See for Firepower 9300:

Table of Contents

Rack-Mount and Ground the Chassis

Figure 34: Secure the Left and Right Rails with the Screws

Step 3

Press the end of the latch to retract and slide the latch on to the rail.

Step 4

Repeat Steps 2 and 3 to attach the rails to the rear post of the rack.

Step 5

Secure the rails to the rack using the four 10-32-in. screws from the rail kit.

Note

Depending on your rack type, you may want to install the 4 retention nuts in the rack before sliding the chassis

in because the chassis is heavy and it may be difficult to install the retention nuts after the chassis is on the

rails.

Step 6

Set the rear of the empty Firepower 9300 chassis on the static rails.

Step 7

Carefully push the empty chassis into the rack until the chassis ears sit flush to the rack posts.

Cisco Firepower 9300 Hardware Installation Guide

Rack-Mount the Chassis

Table of Contents